how is corona effect can be detected??
No Answer is Posted For this Question
Be the First to Post Answer
how works an op-amp
Where are multimode fibers practically used?
What is the need for load flow study?
If we use heat sinkble rechem make HT jointing kit for XLPE HT (6KV)termination at HT side of transformenr, Is it required to fill the HT termination with Epoxy compoud?
how do link aT1 from the 1st BTS to 2nd BTS4?
What are Rectifiers and what is the use of it?
What are the properties of FFT? What happens when you pass a signal of 1000Hz through an FFT?????
What is tristor?
i want to became CCNA,MCSE(server) engineer in our anna university
what is Barkhausen Criterion?
In micro controller individual pin output current is 1.6ma .Normally to blink a led we need minium 10-12 ma. But if we connect led to the micro controller pins without additional device it blinks. How it is possible
why BTS use 48 dc volt