what is the purpose of planetry gears.
Answers were Sorted based on User's Feedback
Answer / ravindra
Main purpose of planetry gear is to providve motion into
different direction with less friction and more torque
Any planetary gear set is composed of three components :
Sun gear
Planet gears and the planet gears' carrier
Ring gear
Is This Answer Correct ? | 8 Yes | 1 No |
Answer / kavan desai
They are used in the applicaions of lower weight ,lower
space ,higher effeciency and most importantly higher torque
transmission
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / annadurai
to get large reduction ratio, They are used in the
applicaions of lower weight ,lower
space ,higher effeciency and most importantly higher torque
transmission
Low maintenance cost
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / ranjit
SPEED VARIATION WITHOUT SHIFTING GEAR(AUTOMATICALY)
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / govind
1.parallel axis gears include high power density.
2.large reduction in a small volume, multiple kinematic
combinations, pure torsional reactions, and coaxial
shafting.
3.planetary gearbox arrangement is load distribution.
4.Because the load being transmitted is shared between
multiple planets, torque capability is greatly increased.
The more planets in the system, the greater load ability
and the higher the torque density.
Is This Answer Correct ? | 0 Yes | 1 No |
What is the difference between pipe and tube?
WHAT IS SPC .
how many stages in compressor in ge 9 fa gas turbine ?
3 Answers Applied Power Technologies, DEWA, Wales Interiors,
What are bevel gears and what are its types?
what is the use of choper motor in pyrometer ?
RRB exam model questions pls forward.
a 20ph motor runnig a load with direct belts, can we use 10hp motor for the same load with the help of gear where motor rpm 900 and load rpm 250
How many isomers have the name bromomethylcyclopentane?
1.In modal analysis ,we can give damping or not? 2.draw goodman's rankine fatigue curve? 3.write down goodman's rankine fatigue equation? 4.IN structural analysis ,out of so many stresses,why von-mises stress are chosen?
newtonian fluids and non-newtonian
What is isometric drawing?
respected sir/madam.. i wish to know about the latest mechanical inventions and improvements... hwere can i get them... please respond to me through my id