what should be the no load current of an induction motor
Answers were Sorted based on User's Feedback
Answer / arun kokje
IT IS DEPENDING ON NUMBER OF POLES OF THE MOTOR.SAY FOR
2POLE AND 4POLE MOTORS IT IS APPROX. 20-30% OF FULL LOAD
CURRENT,FOR 6POLE AND 8 POLE IT IS AROUND 35-45% OF FULL
LOAD CURRENT. FOR HIGHER POLES THE NO LOAD CURRENT EQUALS
FULL LOAD CURRENT DUE CTO POOR NO LOAD POWER FACTOR.
Is This Answer Correct ? | 1 Yes | 3 No |
What is Faraday's law
Why corona takes place?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
what different in delta & star connection in motor?explain
5 Answers Bhushan Power Steel, Hyundai, KPCL, L&T,
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
what is mean by harmonics?Type of harmonics?
What are the different circuits in thermal power plant?
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
what happens to the supply voltage if there is any change in frequency?
How 3 phase invertor works?
what modulation is used in landline telephone signals?