how to calculation increase power factor for single phase
No Answer is Posted For this Question
Be the First to Post Answer
Hi If connecting a temp generator 670KVA .415kv with step up Tx .415/11kv. I am given Generator impedances Z1 Z2 Z0 to 100MVA base. Do I need to work out the generator fault current by using these impedances i.e gen rating / impedance. Then use this as my source impedance for the calculations that follow.
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
in delta connection, why motor rotate in high speed compared to star connection?
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
How much the fault level of 11 k.v.,22 k.v., 33 k.v. (in Maharashtra- M.S.E.D.C.L) for calculation of short circuit current & selection of h.t.cable.
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
why we are using2 wave trap in a feeder?
how make to Incident and accident report
What happen Grid EARTH plat got cut.
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
is there any chance to get shock from the transformer oil at the time of maintenance due to its dielectric property. . ?
in thermal power plant the steam produced is made to cool after falling on the turbine blades. my question is why this is done while the same is needed to heat up again. "jab pani ko wapis garam hi karna hai to thanda kyu karte hai"