current rating of a 3 phase DG set is 20 Amps, but what
will be the per phase current for single phase supply.
- 2 Answers
- 7205 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
single phase current is = three phase current devided by
1.732. Pf consider 1.
| Is This Answer Correct ? | 6 Yes | 2 No |
What does Nominal size in a valve means like NG6,NG10 etc
How scoop works in hydraulic coupling of Motor driven BFP
What is net refrigerating effect of the refrigerant?
how gearbox ratio was calculated?
How much pressure on air reservoir?
what are various part found in vapour absorption machine and its working
what is the use of feed water treatment in boiler?
What is the cause of AHU motor V-Belt wornout
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
What is IS standard in case of mode of measurement for ducting
What is the difference between circular runout and total runout?
what is the purpose of wear rings in centrifugal pumps ?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
