why DG rating in kva
Answers were Sorted based on User's Feedback
Answer / zulfiquar
All the machines we are using like transformer, DG's are
all in KVA becoze at that particular time we dont know the
consumer power factor as we know (Active power= apparent
power x power factor) KW= KVA x Cos phi, that is why we
have machine in KVA rather the KW
| Is This Answer Correct ? | 22 Yes | 1 No |
Answer / jagjeet
Because DG set acting as a power source and supplying
to differnts loads .
| Is This Answer Correct ? | 8 Yes | 6 No |
Answer / subodh kumar
becouse alternatar have two type losses
1. iron losses
2. copper losses
so we find the iron losses in voltage & copper losses find
in amp that is why we take reating in KVA
| Is This Answer Correct ? | 2 Yes | 1 No |
Answer / tarkeshwar
As we know D.G. set i used to generate the Power . it
generate Active power & reactive power(Apperentus
Power=Active Power P+ j Reactive Power Q) and we consume
only active power(KW) that's why the DG rating is in KVA or
MVA, these are the unit of Aperantus Power
| Is This Answer Correct ? | 4 Yes | 6 No |
Answer / g c a
IN DG's load is decided by the users.... wheather it is
inuctive load or capacitve load......... so that's why
it's in KVA
| Is This Answer Correct ? | 3 Yes | 8 No |
Answer / stanley
In DG, the armature has conductor loss (Ia). it give output
voltage with conductor loss. Tth electrical loss is in Amps
(I). So kilo volt +Ampere=KVA
| Is This Answer Correct ? | 3 Yes | 8 No |
How much UG cable size should i use so as to accomodate a ground + 2floors house. A 1.5ton AC & geysers(2) in each floor with lightings
comparision between mcb,mccb,elcb,flcb,elcb in details
how calculate cable size in squre mm, when the load is given by in kw? do u have current rating chart of elctrical cables?
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
To have variable speeds we use a. Induction motor b. Traction motor c. Shunt motor
why generation is done in delta nad transmission in star? brief
what is the major difference between dc generator and synchronous generator?
What is resonant frequency?
can we run all LT motors at 360 volts which are normally rated 415+/-10% voltage rating
define IDMT relay?
15 Answers APGenco, Bhel, L&T, Shriram Finance,
Showing results for capital, machinery, stock,wages, carriage in words, salaries, factory rent, repairs, fuel and power, buildings, debtors, sales, purchases, creditors, return outwords, return inwords, drawings, discount allowed, discount receivable, office expenses, bills payable, bills receivable, cash in hand, cash at bank, office rent comes under debit or credit
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)