When Alarm report at LED,Alarm volatge is 11-13 Volt But
LED is of 3 volt.then why not it burn?
No Answer is Posted For this Question
Be the First to Post Answer
In a house wiring why we are using only one neutral wire and so many phase wires from the main board, when the load is common for both wires?
how to calculate the Neutral transformer impedance?
I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???
As a good company employee, can you report your supervisor to the company management if he or she is going against the company interest in his or her actions?
What is Tachometer used to measure?
WHAT IS THE DIFFERENCE BETWEEN VOLTage and potential diff
What are the types of earthing? Explain dagramatically.
explain the Trip supervision circuit
I want to know if it is possible to use Variable Frequency Drive to reduce the current required for starting a motor?
how to find under ground cable fault ??? if our cable size is 95*4 then what will load capacity with far mull
what is meant by displacement & magnitude ?
What are the advantage of free wheeling diode in a full wave rectifier?