when we given 3 phase supply to ups system, but out put comes with 3 phase + n

when we given 3 phase supply to ups system, but out put
comes with 3 phase + neutral how it possible? pls explain.

Question Posted / ravi

3 Answers
8365 Views
Enzen, Juniper Networks, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

when we given 3 phase supply to ups system, but out put comes with 3 phase + neutral how it possib..

Answer / vinaysuper2000

UPS Incoming supply Delta connection & Out put supply star
connection.

Is This Answer Correct ?

9 Yes

1 No

when we given 3 phase supply to ups system, but out put comes with 3 phase + neutral how it possib..

Answer / logesh kumar.a

the input given system has star connection .so it has 3
phase & a neutral

Is This Answer Correct ?

10 Yes

5 No

when we given 3 phase supply to ups system, but out put comes with 3 phase + neutral how it possib..

Answer / anusree

ups system is a delta star connection , secondary side
grounded in order to allow the flow of zero sequence
currents

Is This Answer Correct ?

6 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

If we give 2334 A, 540V on Primary side of 1.125 MVA step up transformer, then what will be the Secondary Current, If Secondary Voltage=11 KV?

3 Answers L&T,

Whether the Dc motor Droping the power factor like AC motor if lot of motor running in factory is it necessary to connect capacitor bank

2 Answers

If a 1.5V,3W torch light bulb is connected in series with a 15HP/11.19KW,230V single phase motor and the combination is connected against a 230V supply and switched on than what will happen keeping all other parameters as it should be A)the bulb will glow normally B)the bulb will not glow C)the bulb will glow with extra brightness D)the bulb will burn out and if a fuse is connected to the above circuit will something happen to the fuse and what about the single phase motor will it be affected? Please explain with derivation

4 Answers

if the transformer at full load have a iron loss =900w and copper loss = 1600w . what percent of the load will the transformer has a maximum efficiency?

3 Answers

What safety precaution are to be taken for avoiding electric hazards ?

0 Answers

where AVR is connected in power plant.

7 Answers ABB, Saudi Red Bricks,

What is resonant frequency?

0 Answers

what is the difference in operation of 3 phase motor when am forward delta connection and reverse delta connection?

1 Answers Birla,

How to Measure A.C Resistance for Earthing ?

2 Answers

What is the purpose of using busbar mounting fuse?