If we want to move one ms channel on the lm guide. Its channel size is -W-300m

If we want to move one ms channel on the lm guide. Its
channel size is -W-300mm, H-400mm, L - 3ft. then how many
load come on the lm guide. its lm guide is one tipe of
bearing.

Question Posted / dinesh

1 Answers
2791 Views
I also Faced
E-Mail Answers

If we want to move one ms channel on the lm guide. Its channel size is -W-300mm, H-400mm, L - 3ft...

Answer / parth

if concern a UDL then density 7000 kg per meter cube... hence total load= 7000*(300*400*300/1000000000)/1 = 2.5 N/m

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

What are the 1st 2nd and 3rd laws of thermodynamics?

0 Answers

application of two stroke engines

4 Answers

Give me an introduction about myself.iam a engineering student, i would like to know, wat is my qualification till my enginering is not yet completed?

0 Answers

what is different between mechanical seal and oil seal

1 Answers CMS, Essar,

NOW PRESENT WAHT DOING

2 Answers Ecil,

There is a block placed in between air and water. water is at 100 deg cel and air at 50. 1) Draw temperature profile. 2) Why is it curve in air and water?

0 Answers BARC,

• How will you be evaluated at Petro Star Mount, and how often?

1 Answers Petro Star Mount,

Out of constant pressure and constant volume lines on ts diagram which line has higher slope ? And whether slope is constant or variable ?

0 Answers

Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb

0 Answers Saudi Ceramics,

what is tranformer and transducer

0 Answers

hi friends any body please help me i am going to write rrb examination for tecnical trade mech. pls tell me perfect authour name and publicataions for rrb objective type mech engg or any other options to prepare

2 Answers IUAC, RRB,

Please brief me reation between timing belt & gear ratio.

1 Answers Wipro,

For more Mechanical Engineering Interview Questions Click Here