Answer / rohit bhutani

the pump would not be able to take in as much fluid as the
amount of suction pressure created.. this would lead to
cavitation (its nt capitation)... the effects of cavitation
are as per described in the last answer.. damage to impeller
blades, increased vibrations, etc..
this is the only reason that for controlling the flow we use
a valve at discharge line rather than the suction line...

Answer / dodi

flow and pressure to the discharge line shall reduced as
appears on the pressure gauge, and capitation could be
happening of the pump immediately, high vibration,
temperature raised, and culminate in the pump parts getting
severe damage

Answer / abdul hameed

In case of Centrifugal Pump:Restricted entry (suction) to
the pump, will lead to CAVITATIONAL effect. This will not
only affect the performance of the pump, but also can creat
damage to impeller and casing material.

Answer / mistryhardik89

i m agree vth Kathiravan simply if u control suction
valve,it draws less liquid means flow makes high pressure
which needs low current.and discharge side we get high
pressure which give us high dp leeds to cavitation.......
am i right?

Answer / bn

Depends !
The differential pressure across the pump will be increased.
The pump flow will decrease. How much it decreases depends
on the pump type. If the suction is throttled
sufficiently, pseudo-cavitation and/or cavitation will
occur.
Much better to the throttle the discharge providing it
isn't a pd pump. Much better, more efficient, to size the
pump correctly in the first place !
Approximate system parameters gets you an approximate
(usually inefficient) pump !

Answer / ankita

enthalpy remains constant

Answer / karan

If it is throttled than it works as a convergent nozzle and
the area of suction will increase.

Answer / kathiravan

Motot draws less current.
Discharge Pr will decrease
Discharge flow gets decreased
Pump tries to suck air.
Better throttle Dicharge valve

Answer / karthick

the discharge increases

What is the difference between a mechanical engineer & a Marine engneer?

0 Answers   SKF,

hi this is swaroop i appliled for masters in us for mba and my ielts score is 5.5 and no gre and i have 14 backlogs

0 Answers  

While selecting a diameter of 1 inch which pipe is better, ERW or Seamless ?? OR Out of ERW and Seamless which one gives good results for an impact force of 2700 N??

1 Answers  

In which industrial process you will use centrifugal separator

5 Answers   Focus Energy, IOCL,

what is C.H.R. in industries.

1 Answers   Graphite India, HMT,

best tip to increase fuel efficiency with a high powered engine?

1 Answers  

Stress produce strain or strain produce stress.....?Explain?

9 Answers   Behr, Bhel, ONGC,

What is machine

6 Answers  

1.In modal analysis ,we can give damping or not? 2.draw goodman's rankine fatigue curve? 3.write down goodman's rankine fatigue equation? 4.IN structural analysis ,out of so many stresses,why von-mises stress are chosen?

1 Answers   Infotech,

What are the defects in exhaust valve?

0 Answers  

What is the difference between scavenging and supercharging ?

0 Answers  

define jig and fixure?what is diference between jig and fixure?

12 Answers