Hi everyone.. I attended the HAL interview... on 9th dec
2008 @ Bangalore.. the interview was 90% technical... my
question are>>>>>
1) Design a rod that should withstand 1000N? (they told
that the material is mild steel & they gave me the stress-
strain graph for that)
2) what is the principal of hydraulic braking??
3) whether interchangebility is possible between JIGS &
FIXTURES???
4) what is recent developement in Automobile ENGINE???
5) abt my final year project (since i m a fresher)
6) some HR questions
Answers were Sorted based on User's Feedback
Answer / karthick
3.interchangability is not possible in jigs and
fixtures.because fixtures are just work holding device.they
cannot guide the tool to pass through whereas jigs can hold
the workpiece as well as guide the tool w.r.t to the
contour of the jig.
4.some recent developments are DTSi engine,Power steering
system,DDiS engine,MPFI engine,anti-lock braking system etc
Is This Answer Correct ? | 27 Yes | 0 No |
Answer / naveen kurakula
The Hydraulic brake system works on Pascal's law, which
states that " Pressure applied anywhere to an enclosed body
of fluid is transmitted equally to all parts of fluid.
Is This Answer Correct ? | 13 Yes | 2 No |
Answer / sat
hydraulic braking basic principle
pressing brake pedal..........exerts force on master
cylinder which in turn sends fluid into individual brake
cylinders which inturn exert force on brake shoe-pad device
to brake the wheel
for clear info check
http://www.tpub.com/content/engine/14037/css/14037_67.htm
Is This Answer Correct ? | 9 Yes | 3 No |
What is a seal?
in a pump, impeller wear ring is harder or casing ring? why?
What do you understand by heat treatment?
What is the difference between induced draft cooling tower& natural draft cooling tower?
relation between head,capacity & rpm
What is the ratio of specific heat of air?
If I can absorb 9,000 lux of sunlight in the bottom of a pool what will the temp rise be per hour, per square foot of absorbing material, per gallon be? Temp of pool deck 115 degrees, water temp 75 degrees, 120,000 lux on the pool deck
when do we use roller bearing, deep groove ball bearing, angular bearing, sealed bearing, semi sealed bearing, unsealed bearing, anti friction bearing, journal bearing, thrust bearing
Im studing engineering, i wanna do MBA ftr engineering Is there any scope f doin mba ftr engineering??
why cenrifugal pump casing is called involute casing.
The pattern material used in Investment casting Process is?
what should do to reduce the breakdown of fire water pump?