what is the difference between LATCH and FLIP FLOP

Question Posted / navas a.

4 Answers
7424 Views
Wipro, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is the difference between LATCH and FLIP FLOP..

Answer / sriram

flip flop is a sequential device that samples its input and
changes its output at time determined by clocking signal....
where as latch is d one that checks its input and changes
its output at any time independent of the clocking signal......

Is This Answer Correct ?

8 Yes

2 No

what is the difference between LATCH and FLIP FLOP..

Answer / sennapparajan

basically both logic is same.

flip flop has tow out puts Q and inverse Q.its doesn't
change out put untill its get in put for set or reset.

latch:when input is high the out put of the latch is
active.when ihput is zero its out does'nt change. it wil
change the out put only when the scond time input is high.

Is This Answer Correct ?

1 Yes

0 No

what is the difference between LATCH and FLIP FLOP..

Answer / devansh

Lets make it more transparent. A Latch is used to hold a
signal even when the input is removed and changes only when
a second input strikes.
On the other hand, a flip flop is a sequencial circuit that
renders an output depending on the input signal and
previous state(D flip flop an exception) after the given
clock pulse.

Is This Answer Correct ?

1 Yes

0 No

what is the difference between LATCH and FLIP FLOP..

Answer / tamil

FLIP FLOP is one bit memory device but LATCH is not a
memory device

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

how can we measure rotor current of a 3phase wound rotor induction motor connected to liquid resistance starter

1 Answers

The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.

0 Answers

Why capacitor is blow when I am starting motor ?

1 Answers

how to calculate the chiller load from TR to KW?

0 Answers

Why double earthing is required ?

1 Answers

what type of earthing do for dry fissure rock?

0 Answers

I want to know if it is possible to use Variable Frequency Drive to reduce the current required for starting a motor?

3 Answers Descon,

Disadventage of cable-gland earthing if any ?

0 Answers

10 hp motor ,7.5 kw ,960 rpm, full load current 15.5, delta connection so how much take current no load trial time. any formula please give..... second question :- what is different between brekar control wiring and motor starter control wiring

1 Answers MSP,

how oti and wti connections are different from each other?

0 Answers

what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?

0 Answers Faurecia,

what is the difference between ELCB and RCCB

5 Answers Concorde, Hyundai,

For more Electrical Engineering Interview Questions Click Here