how LT meggar works
Answer / deepak
The moving system consists of two coils, the "control coil"
and the "deflecting coil"-rigidly mounted at an angle to one
another and connected, in parallel across a small generator,
with polarities such that the torques produced by them are
in opposition. The coils move in the air gap of a permanent
magnet. The control coil is in series with a fixed control
circuit; the deflecting coil is connected in series with a
fixed deflecting circuit resistance and the resistance under
test. If this last is infinitely high no current flows in
the deflecting coil and the control coil sets itself
perpendicular to the magnetic axis, the pointer indicating
"Infinity." A lower test resistance allows current to flow
in the deflecting coil and turns the movement clockwise. The
control torque produces a restoring torque which
progressively increases with the angular deflection, and the
equilibrium position of the movement is attained when the
two opposing torques balance.
Is This Answer Correct ? | 7 Yes | 2 No |
Which rccb 30ma,100ma,300ma sensitivity should be used in domestic line and what is difference, advantage and disadvantage of all three
what is the purpose finding power factor?
If we have 15000kw connected load in a factory than how much power demand sanction should be taken from electricity board. Pls provide complete calculation.
how do we calculate length of starting time and repeated starting of a direct online starter?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
WHAT IS THE REASON OF CHANGE FREQUENCY IN DG SET AFTER FULL LOAD.
What is BMS System???Types...
What is the need for a controller?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
What is phase in electrical engineering?
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?