Answer / chandu

ejection system will make to remove the produt/component
from the mould with out any damages

Answer / b.mohan

1.pin ejection, 2.blade ejection, 3.lifter ejection, 4.pad
ejection, 5.sleve ejection.

Answer / mansi hazra

ejection system in a mould making process means removal of
hot gases like hydrogen etc that are trapped during pouring
of molten metal into the casting. for mould making.also
some excess moisture are eliminated through this system.to
facilitate easy ejection riser is procided.

where multistage pump used

2 Answers  

---

what is the meaning of rheostat in maximum and minimum position?

0 Answers  

---

what's the diffrent between k engine series and qsk engine series and specialey fuel system

0 Answers   Cummins,

---

Explain why you consider yourself suited for the Position:

0 Answers   L&T,

---

What do you treat in high alkalinity of boiler water? What is a feed water pump? What is a Booster pump?

0 Answers  

---

What is a Stirling engine?

8 Answers  

---

what is the required force to bend 2.5 MS sheet in 90 degrees and what is the formula to calculate the same?

0 Answers   Voltas,

---

Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com

0 Answers  

---

what is presure?

5 Answers   IGCAR,

---

when pump is maitaind throughly and installed perfectly then why pump vibrates on above standard vibration level?

4 Answers   IOCL,

---

What is the importance of tolerance in engineering?

0 Answers  

---

how many types of jacks

0 Answers  

---