duplex system means
Answers were Sorted based on User's Feedback
Answer / prabhash
it is a system in which two way communication can be done at
a time .
Is This Answer Correct ? | 11 Yes | 0 No |
Answer / arun prabhakar
Duplex is a two way communication system at a single point
of time. You can send signals and also receive signals at
the same point of time.
Is This Answer Correct ? | 11 Yes | 0 No |
Answer / shweta
duplex is of two types one is half duplex and other is full
duplex. In full duplex there is two way communication
whereas in half duplex there is one way communication.
Is This Answer Correct ? | 7 Yes | 1 No |
Answer / yuvaraja
its a transmission modes used for communication . it has 2
types 1 is half duplex 2 is full duplex..
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / anindita banerjee
full duplex system is also called duplex system where
systems at both ends can act as transmitter and receiver at
the same time.
Is This Answer Correct ? | 4 Yes | 1 No |
Answer / arun kumar
it is communication mode system.it may be half(waki taki)or
full(telephone)
Is This Answer Correct ? | 0 Yes | 1 No |
How can I understand electronic/electrical panel wiring & drawing?
in optical fiber cabels, which type of losses can be occured, and how the signal-loss happens?
Consider a fixed subnet partition of a class B network number that will accommodate at least 76 networks. How many hosts can be on each network? Also mention how you calculated that.
What is a mosfet? How is it different from a jfet? What are its typical applications?
What do you mean by electronics? How is it different from electrical?
0 Answers HPCL, Hughes Systique Corporation,
IN GENERAL PRACTICE HOW KVAR AND CAPACITANCE VALUE OF CAPACITOR CALCULATED?
In 8086 why even address location takes two bus cycles whereas odd address location takes only one bus cycle??
Plot the pixel histogram( take any image) – count of values versus pixel intensity 0 to 255. You must write this from first principles – do not use the MATLAB hist command (although you may use it for comparison and checking your algorithm’s correctness). Plot the cumulative histogram. Do not use the cumsum function in MATLAB (write your own function to achieve this).
What are the frequency compensation methods?
What is used for high speed reading and storing of information in a computer?
What is meant by voltage commutation?
Define negative frequency?