Answer / sankha banerjee

Mainly needed water, Flux , refractories , silica , ferro alloys.

The stage below saturation is called? Cox chart is used in ....Distillation, evaporation, drying r none?

3 Answers   TCE,

---

How do you define mechanical efficiency in case of compressor? How it is different that of an IC engine?

0 Answers  

---

what are engines that use carburetor and that use inductor ? difference between them

6 Answers  

---

Which two elements have same percentage in proximate and ultimate analysis of coal?

0 Answers  

---

What is dtsi? Why it is used in motor bikes?

0 Answers  

---

why desuperheater tubes are bend in shape

0 Answers  

---

In volute casing the discharge area is more. so as per bernoulli's principle the pressure must be reduces also from the basics, pressure = Force/Area. so pressure and area are inversily proportional. By considering these two basic rules pressure must be reduces. But in any centrifugal pump, the pressure is increasing. How the velocity is converted into pressure. In my view only head is increases but how the pressure increases?

2 Answers  

---

how gearbox ratio was calculated?

7 Answers   Reliance,

---

An Rod of 25mm in dia, is bend and made into a circle Ring with outer dia 200mm, then what ll be the length of rod required?

2 Answers   SSK,

---

HOW CAN WE MEASURE THE L SHAPE SURFACE OF THE MOMENT OF INERTIA AND SECTION MODULUS

0 Answers  

---

What is process flow diagram?

0 Answers  

---

i am very much confused about direction of thrust in steam turbine...we have steam turbine of 13 stages,10 stages of impulse and 3 of reaction type....in study manual direction of thrust is towards inlet but on thrust bearing its loading side is towards condenser(exhaust side) wile also dummy ring is present in design which also restrict rotor to move in exhaust side direction not inlet ....

2 Answers  

---