who discoverd ohms law?
Answers were Sorted based on User's Feedback
Answer / mathan
German physicist GEORG OHM at 1987..the ohm law is V=IR.
V- Voltage in volt
I- Cirrent in amp
R- resistance in ohm
the ohm's law states that, voltage is equal to the current
times resistance.
| Is This Answer Correct ? | 11 Yes | 1 No |
Answer / bliss
one thing i would like to inform that ohm's law has been
challanged and a new deffination where the temperature
should remain same when you take results.... because the
resistance changes when temperature changes.
The name written above is corrct "george simon ohm"
| Is This Answer Correct ? | 7 Yes | 2 No |
what is the working principal of pribe
what is the difference between Digital output DO signals /Commands for start/stop and Solenoid valves ??
What do you know about gail?
two common seiling liquid used in seal pots are:
what is three element loop
why use on -off control valve in glove valve
what are the following documents comes under loopchecking
procedure to commission a drum level transmitter
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
How to work DCS? how to get the signal from Field Instruemtns to PIB to Console?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)