How much maximum power can be generated by 320v, 10kg-cm synchronous motor if shaft is rotated mechanically at 50 to 60 rpm?
No Answer is Posted For this Question
Be the First to Post Answer
Explain what is the significance of the minimum flow required by a pump?
Explain what are some good uses of low-grade steam at 12 atm and 1920c?
Question 83 - The United States of America Energy Information Administration reports the following emissions in million metric tons of carbon dioxide in the world for year 2012 : Natural gas : 6799, petroleum : 11695, coal : 13787. Coal-fired electric power generation emits around 2000 pounds of carbon dioxide for every megawatt hour generated, which is almost double the carbon dioxide released by a natural gas-fired electric plant per megawatt hour generated. If 1 metric ton = 1000 kg and 1 pound = 0.4536 kg, estimate the total energy generated by natural gas in the world for year 2012, in gigawatt hour.
NATURAL GAS ENGINEERING - QUESTION 26.2 : (a) The Hyperion sewage plant in Los Angeles burns 8 million cubic feet of natural gas per day to generate power in United States of America. If 1 metre = 3.28084 feet, then how many cubic metres of such gas is burnt per hour? (b) A reservoir of natural gas produces 50 mole % methane and 50 mole % ethane. At zero degree Celsius and one atmosphere, the density of methane gas is 0.716 g / L and the density of ethane gas is 1.3562 mg / (cubic cm). The molar mass of methane is 16.04 g / mol and molar mass of ethane is 30.07 g / mol. (i) Find the mass % of methane and ethane in the natural gas. (ii) Find the average density of the natural gas mixture in the reservoir at zero degree Celsius and one atmosphere, by assuming that the gases are ideal where final volume of the gas mixture is the sum of volume of the individual gases at constant temperature and pressure. (iii) Find the average density of the natural gas mixture in the reservoir at zero degree Celsius and one atmosphere, by assuming that the final mass of the gas mixture is the sum of mass of the individual gases. Assume the gases are ideal where mole % = volume % at constant pressure and temperature.
Explain how instrument air is continually supplied in process plant?
Please help to get IOCL/HPCL or other chemical engineering paper pls send kathir_skv@yahoo.com Regards, kathirvel
What is the maximum recommend pipe velocity for dry and wet gases?
how does the properties of an element changes by increasing protons and electrons?
What are the uses of quicklime?
What is formula for petrol?
significance of fouling factor in shell and tube heat exchnager
What is an effective means of removing silicon from aluminum?