what is the apt definitions for apparent power ,active power and reactive power?and explanation about different types of lamps?

0 Answers  

---

A concentric, counter-current heat exchanger is used to cool lubricating oil. Water is used as the coolant. The mass flow rate of oil into the heat exchanger is 0.1 kg / s = FO. For oil, the inlet temperature TIO = 100 degree Celsius and the outlet temperature TOO = 55 degree Celsius. For water, the inlet temperature TIW = 35 degree Celsius and the outlet temperature TOW = 42 degree Celsius. What is the mass flow rate of water in kg / s, FW needed to maintain these operating conditions? Constant for heat capacity of oil is CO = 2131 J /(kg K) and for water is CW = 4178 J /(kg K). Use the equation (FO)(CO)(TIO – TOO) = (FW)(CW)(TOW – TIW).

1 Answers  

---

What factors go into designing the vapor space of kettle type reboiler?

0 Answers  

---

how can we measure entropy?

1 Answers  

---

why transmission lines using 220KV.

2 Answers  

---

---

HOW WOULD YOU CALIBRATE A ROTAMETER

2 Answers   IOCL,

---

Question 94 - The resolution of separation, Rs for chromatography is given by the formula Rs = (difference in retention time) / (average width at the base). In a chromatogram, 3 peaks a, b and c are found. Average widths W at the bases of the solutes are : Wa = 20 s, Wb = 40 s, Wc = 30 s. Resolutions of separation, Rs for solutes b and c in comparison to a are 2 and 4 respectively. The differences in retention times T for b and c in comparison to a are (Tb - Ta) and (Tc - Ta), Ta = Tc - Tb : (a) Form 2 equations involving Rs as a function of Wa, Wb, Wc, Ta, Tb and Tc. (b) Find the values of Ta, Tb and Tc.

1 Answers  

---

Explain what is a quick way to calculate frictional pressure drops in carbon steel pipe?

0 Answers  

---

How much maximum power can be generated by 320v, 10kg-cm synchronous motor if shaft is rotated mechanically at 50 to 60 rpm?

0 Answers  

---

How can one determine if a particular solid can be fluidized as in a fluidized bed?

0 Answers  

---

Question 62 – The names of the flow streams could be represented by : H1 for first hot stream, H2 for second hot stream, C1 for first cold stream, C2 for second cold stream. Data of supply temperature Ts in degree Celsius : 150 for H1, 170 for H2, 30 for C1, 30 for C2. Data of target temperature Tt in degree Celsius : 50 for H1, 169 for H2, 150 for C1, 40 for C2. Data of heat capacity Cp in kW / degree Celsius : 3 for H1, 360 for H2, 3 for C1, 30 for C2. (a) Find the enthalpy changes, dH for all streams of flow H1, H2, C1 and C2 in the unit of kW. Take note of the formula dH = (Cp) (Tt - Ts). (b) Match the hot streams H1 and H2 with the suitable cold streams C1 and C2 to achieve the maximum energy efficiency.

1 Answers  

---

What are the some common causes of control valve noise?

0 Answers  

---