Answer / mechy08

There are a number of machinig processes,but all these are
classified under two categories,viz:-
1.)Conventional m/c or Traditional m/c
which are done on conventional machines like
lathe,shaper,grinding etc.
2.)Non-Conventional m/c
which are done by the applications of those methods which
are well developed eg:-ECM,WJM,AJM,EDM,USM etc

Answer / suryamack

turning,shaping,milling etc.

Answer / marx

Two Types of Machining processess

1:Traditional
This includes processess like drilling,turning,
milling,shaping,planing and grinding.



2:Non_Traditional
This includes processess like ECM,EDM,AFM and USM.

Answer / karthick

milling,grinding,broaching,shaping,planning,drilling and
all lathe operations

Answer / bradeesh moorthy .s

Processes in which material is removed are called as
machining process. The classification are traditional like
drilling, turning, planing, milling, slotting etc and non
traditional like EDM,ECM,Ultrasonic machining etc.

Answer / girish

A-There are two types of machining procees are held.
1)conventional m/c
2)non conventional m/c
1.conventional m/c processes is the process in which the
m/c tool touch the job and cut the meterial accoding to the
requarment to give the shape & size.
EX- lathe, milling,drilling,grinding..etc
2)In non conventional m/c,the tool does not touch the job
but it give,maching product.like.
EX-ECM<EDM,wire edm..etc

Answer / wesly

CONVENTIONAL ; MILLING AND LATHE OPERATION AND SHAPER ETC
UNCONVENTIONL ; ECM,WJM,AJM,EDM,USM etc

Which furnace burns low-ash fusion coal and retains most of the coal ash in the slag?

0 Answers  

Explain the difference between grey iron and white iron. What is mottled iron ?

0 Answers  

what is bearing? how many types of bearing

7 Answers  

WHAT IS THE LOWER LIMIT & UPPER LIMIT WHEN DIMENSION IS 9.0- 0.042-0.027

3 Answers   ASD Lab, Brady,

What is meaning of bearing nos.?

4 Answers   Grasim, IOCL, L&T, Sharp Ferro Alloys,

what is the cause of erratic misfire in DG

1 Answers  

What is the difference between Mild Steel and Cast Steel with full chemical composition and application details.

0 Answers   DAE,

what is the significance of line of action in gear?

0 Answers  

what is difference between stress and pressure ?

10 Answers   TATA,

Which pipe should I use SAW, ERW or seamless if I have the following constraints I have to transport methane gas Size is 8” Corrosive environment Sulphide is present Also tell the cost comparison

0 Answers   SMEC,

how calculate the bearing number from inner and outer dia of bearing

0 Answers   Devashree Ispat,

What are the factors that can affect the factor of safety selection?

0 Answers