What is pan hard rod or track bar?

0 Answers  

---

what is the syllabus for the rrb sec. eng. posts iam from automobile engg.

0 Answers   RRB,

---

Propeller shaft is used for the purpose of a) Transmitting the drive from the transmission to the bevel pinion of the final drive b) Transmitting the drive from the crankshaft to the road wheels c) Transmitting the drive from the transmission to the road wheels d) Transmitting the drive from the crankshaft to the bevel pinion of the final drive

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

Why do heavy vehicles use diesel engine?

0 Answers   GM General Motors,

---

If the tractive effort is the highest for a given velocity, then the vehicle must be in a) Top gear b) Third gear c) Second gear d) First gear

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

---

What is the size of the recommended compressor cfm?

0 Answers  

---

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is the allowable -ve carnkacse pressure (vacuum) in the gas engine of 1.5 MW, what are the reasons and how it can effect the operation of the engine?

0 Answers  

---

What will happen if someone adds oil to the fuel of four stroke bike engine?

0 Answers  

---

What are internal combustion engines?

0 Answers   Ashok Leyland,

---

What is an injector pressure in heavy vehicles? Why it is used?

0 Answers  

---

If the given tractive effort curve and the total resistance curve does not intersect, then a) The vehicle will accelerate b) The vehicle will decelerate c) The vehicle will not be able to go at this gradient for the given gear d) None of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---