We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible

0 Answers  

---

what is the working principle of three point starter of dc motor?

1 Answers   Ashok Leyland, Cap Gemini, Infosys, Just Dial,

---

what is the basis for selection of Protection CT class ? How anyone can decide whether to go for 5P10 or 5P20 ?

3 Answers  

---

what is overflexing in transformer? setting?

1 Answers  

---

how to read idmt curva

0 Answers  

---

what happend if the protection ct is by mistake put instead of measuring ct & vice versa?

2 Answers  

---

why the projects getting loss?

0 Answers   SBPL,

---

- two pumps must work with them at the same time but if the first pump start the second pump  must delayed for some time to start  also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it

0 Answers  

---

What is mean CT Saturation? How to calculate?

3 Answers   NetGroup, Tyco,

---

why we are using DC supply in megger?

3 Answers   TATA,

---

Why we use cosine angle for calculating power factor not in sine angle ?

4 Answers  

---

galloping in transmission line is due to

2 Answers   DVC,

---