we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 M

we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan

Question Posted / tariq

0 Answers
1685 Views
RYK Mills, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

Earth leakage relay basic knowledge principle

0 Answers Radiant,

How to identify the whether its an isolator or Breaker in MDB

5 Answers

A 6-pole, 50 Hz, 3-phase synchronous motor and on 8-pole, 50 Hz, 3-phase slip-ring induction motor are mechanically coupled and operate on the same 3-phase, 50 Hz supply. If they are left open-circuited, then the frequency of the voltage produced across any two slip rings would be

2 Answers L&T,

If load is 240 kw & pf is 0.8 lagging, than how to increase it from0.8 to 1.0(unit),which rating capacitor used, please give me Calculation. What is effact of consumer & suplier if pf is lagging or leading with on effect machines/ TF/GE etc.

6 Answers L&T,

what is the difference between Resistance VS capacitance

2 Answers Jindal,

what is the difference between scaler and vector control in drive and where it is to be used ?

1 Answers Essar, TCS,

Why temperature rise test is conducted in bus bars and Isolators?

5 Answers Areva,

why maintain the Dg PF is 0.8? Explain?

4 Answers

WHY WE NEED NEUTRAL FOR 3PH 400 OR 415 VOLTS POWER SUPPLY (4 WIRE SOURCE).

5 Answers

Does the dg syncronization sucessful in practical.