Answer / akash narayan shrawane

Condenser is a divice which is use to reject the heat... It convert the high pressure vapour in to liquid

Evaporator is a divice which is absorb the heat and convert liquid fluid in vapour

what is the termodynamic?

5 Answers  

---

From where compressor recive power in automobile?

1 Answers  

---

WHAT SHOUL BE THE RAKE ANGLE WHEN SS IS TO BE MACHINED

3 Answers   Engineers India, Engineers India Limited,

---

Explain how is martensite structure formed in steel?

0 Answers  

---

can any body sand me previous exampapers of jr. engineer (mechanical)

0 Answers  

---

---

What is a magnetic valve of refrigeration system?

0 Answers   RRB,

---

When you will install a new piston ring, what will be the position of it?

4 Answers  

---

THIS IS HARI PRASAD. I KNOW THAT HVAC MEANS HEATING VENTILATION & AIR- CONDITIONING. I NEED DESIGN CONSIDERATION OF HVAC UNIT.

0 Answers  

---

what is the highest critical temprature of refrigerant?

2 Answers   Hitachi,

---

why the stroker is provided in the boiler?

1 Answers  

---

25 questions in 25 minutes were asked by L&T corein mechanical engg test on 28 nov 2011 are as follows:- L&t mechanical consists of 1> airfuel ratio 2> mollier chart for flow rate 3>homogeneous or hetreogeneous mixture 4>sublimation curve 5>effect on room temperature when fridge is opened 6>cop of refrigerator 7> punching and piercing uses shear or not 8>method not used for tapering 9>forming method not used for productn 10>numerical regardng no.of cuts 11>flow of chip is controlled by which parameters 12> property important for impact loading 13>stifness of spring when it is cut into 2 pieces 14> device reqd for energy fluctuation 15> property on which rivet is selected 16>crowning to prevent flat belt pulley errors like undercut 17>cavitation occurs at which stage 18>qstn regardng inventory control 19>for ship vessel industry what sort of plantlayout reqd 20>value engg definition 21> qstn on how the extnsn occurs for uniform loading 22> qstn regardng stress actng on the shaft23>maximum value of mohr's circle diameter 24>qstn regardng meshing of teeth 25>qstn on helical gear reqrd better read G.K.PUBLISHERS GATE PAPERS ESPECIALLY FROM 1993 to 2003 ESPECIALLY THEORY QUESTIONS RATHER THAN NUMERICAL QUESTIONS

0 Answers   L&T,

---

I was absent for a 4 supply exams.. Will there any credit decrease for that exams in r16 regulation7

0 Answers  

---