What is the drawback of class b amplifier? How is this minimized?

0 Answers  

---

why HT wire making noise?

3 Answers  

---

the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?

0 Answers  

---

What is IDMT relay how it works.

3 Answers   Electrotherm, Sulzer,

---

what is the current law ?

4 Answers   Aster, TCS,

---

The electromagnetic torque developed is proportional to what in a D.C series motor?

0 Answers   HPCL,

---

In Energy meter How many rotation Equal to one unit.

3 Answers  

---

What is an Automatic Voltage Regultor & what is its use? What are the general componets we use to design an Automatic Voltage Regulator..What are the factors to be considered for its design?

3 Answers  

---

Why in india freq. is 50HZ & in U.S.A. it is 60HZ?

2 Answers   MacLellan,

---

Questions :- HR- Q.1 about yourself & family background ? Q.2 Why u choose Power sector as ur carrier starting not any other sector ?? Q. 3 What think abt NTPC ? Techincal Questions:- Q.1 about Vocational Training……What u did , see the main equipments….etc Q.2 Why a transformer Noise during its running condition ? Q.3 about transformer oil material & Test name for the measurement of its dielectric strength & wht will u do if its dielectric strength goes low ? ……..some discussion type ? Q.4 What is relation between transmission lines & Communication lines ? Q.5 Which Machine u will prefer to use at a place where flammable gases are coming out & why ? Q.6 how fault in an electric system is detected & hw protection of equipments is done ? Q.7 Why we didn’t feel electric shock in an electric train ?? Q.8 Anything u want to ask from us ??

44 Answers   Akona Engineering, Bhel, BSES, Cranex, DRDO, JCB, NTPC,

---

what are the types of cooling systems used in motors?

2 Answers  

---

There are two nos of 33Kv/11Kv 5MVA transformers conecting through HT cable from substation having metering at substation itself.One transformer used at a time another remains stand by.Further 11 nos of 11Kv/440V transformers are attached on it and each transformer is having its own Power factor correction panel.Now one 33/11Kv transformer at no load condition/Stand by condition is having power factor in leading side upto 0.21 and while when another tranformer at same situation have power factor in lagging 0.42. Now one thing is clear that transformer one is having 1.5 Km long 33kv cable due to that PF goes in leading side and another is having only 250 mtr length remains him lagging. Now i want to know that how i can maintain the Power factor at no load/ stand by position though both are behaving in seperate manner.

1 Answers  

---