Answer / shivam

POT bearings is placed under each end of girder it's function is to take up horizontal load and act as a shock absorber
PIN bearing is placed under tie beams or cross girders it's opposite of pot and aims at absorbing vertical load and earthquake resistant

Why we use Reinforcement out side of the column not in centre

4 Answers  

---

i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr

0 Answers   National Construction Authority,

---

what is means of M50,M20,M15 like this please tell me ?

0 Answers  

---

what are the functions of wall

2 Answers   ATS, Gammon,

---

how can i determined the size of burfi ring?

1 Answers   Interior Designs, Simplex,

---

---

in a mix if desired concrete slump is not obtained , the adjustment of each concrete slump difference is made by adjusting water by which percentage

2 Answers  

---

Why you are leaving present job?

0 Answers   HCL, L&T, NCC,

---

Why are we providing crank in beam? Thanks.

2 Answers  

---

what will be the cost of constructing a plinth of (40x40x4)ft and a PCC layer of 4 inches?

4 Answers  

---

what is period of de-shuttering for different area of slab of M25 grade?

2 Answers   ATS,

---

which type of instrument included in plumbing work?name of instrument?

0 Answers   Gammon,

---

what is the stripping time of beam column & slab?

2 Answers  

---