Answer / hussainngx

In case of radar type level Tx .For level its range is 0-100 % . But we have to configure some parameters like empty/full calibration , dielectric constant, mapping . For configuring these parameter we need level sketch of the tank.

What is the basic difference between 2 Wire, 3 Wire and 4 Wire RTD

2 Answers  

---

What is the reason PT speed not incresed in gas turbine?

0 Answers   ROC,

---

In closed loop control there are several “blocks” used to show the interactions between the process and the control system. These blocks are referred to as the “process” and the “controller.” Describe the relationship between these two blocks when creating a well tuned control loop.

1 Answers  

---

Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....

0 Answers  

---

what is the hydra step level sensor output value( measuring level of steam drum)

3 Answers   Adani, ITPS,

---

what is the procedure of O2 analyser calibration?

3 Answers   Thermax,

---

What is difference between scada and virtual instrumentation?

1 Answers  

---

What does a hookup diagram look like? can you give sample drawing. thanks.

1 Answers  

---

If we increase only P what will be controller action ?

0 Answers   IMECO,

---

how to adjust relay in smart positioner ?

1 Answers   SipChem,

---

How to calculate the flow rate in Vortex flow meter?What is K factor?Can you give me an example calculation to understand the same as better?

1 Answers   npcc, Zadco,

---

why the output sugnal is 4-20 ma and not 4-25 ma?

5 Answers  

---