Answer / hameedwahab

ID Fan: It handles high density flue gas.
It's Vane angle is more.
It works as an Exhaust Fan.

FD Fan: It handles Fresh Air.
It's Vane angle is less.
It works as a Supply fan.

Answer / ankushkalia

ID is "Induced Draft" and FD is "Forced Draft." In an induced draft system, the fan is at the exit end of the path of flow, and the system is under negative pressure - that is, the pressure in the flow area is below atmospheric, because the air is being drawn through the fan. In a forced draft system the fan is at the entry end of the path of flow. It operates at positive pressure because outside air is drawn into the fan and forced into the system.

Answer / vinu

ID fan has axial suction and radial discharge
FD fan has axial suction and axial discharge

How many lubricating holes are there in cylinder?

1 Answers   RRB,

---

What are the safety devices in generator.

13 Answers   ABB, Anand Group, ITC Infotech,

---

What are the causes of low compression in the main engine?

0 Answers   RRB,

---

how i can calculte the lenght of a ring dia 27 mm.

5 Answers   TATA, WWE,

---

What is Structural steel Fe-500 as per IS 226-1975 ?

1 Answers  

---

---

Why is a condensor used in a rankine cycle?

8 Answers   BARC, Bhavini,

---

how much efficiency loss will tool place in a steam turbine due to low vaccum?

0 Answers  

---

Difference between isometric & trimetric view

1 Answers   Adani,

---

what is the use of feed water treatment in boiler?

2 Answers  

---

How to calculate motor bearing life - cycle (life time) (SKF bearing) how determine the capacity of refrigeration system? how we use condenser coils, compressor, capillarity,compressor how determine the capacity of refrigeration system? how we use condenser coils, compressor, capillarity,compressor what is rigging

0 Answers  

---

what is priming pump? state function.

3 Answers  

---

what different between centrifugal pump and positive displacement pump

6 Answers   IGCAR,

---