what is difference between E/P positioner and I/P positioner. Why E/P fixed in below actuator and why I/P fixed in other place

1 Answers  

---

which instrument is used to study the structure of phloem and xylem tissue?

1 Answers  

---

what is the safety integrity levels (SIL)

1 Answers  

---

where proximity sensor installed on tank in loading arm application

0 Answers  

---

How much should be the values and/or percentages of these given below factors for a good controller ? Steady state error Delay Rise Time Overshoot Peak Time Settling Time Damping Oscillations & vibrations thanks

1 Answers  

---

how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?

0 Answers  

---

Dear all... I have 1 0-400 duplex type RTD, I connected the A side to the temperature indicator and B side to the PLC panel, but when I have observed then found that The PLC side temp has the variation. and it was distub to other RTD temp also. so what can I do.

1 Answers  

---

Why the Air Tank Accumulators required for the single acting actuators SDV's or BDV's as I see in some Schematic diagrams of ROTORK ??

2 Answers   L&T, Siemens,

---

draw the block diagram of a level transmitter ?

0 Answers   Hira Group, Samsung,

---

What is the Difference between PE,IE and ISE

2 Answers  

---

What is difference between loop and zone ?

5 Answers   Adgas, Bilt,

---

If we interchange HP and LP tapping in drum level measurement and reverse LRV & URV correspondingly.What is the difference between the normal tapping(HP,LP) and reversed tapping(LP,HP)?

2 Answers  

---