If any cable burnt how can we identify it burnt by high current of high voltage?
No Answer is Posted For this Question
Be the First to Post Answer
What type of bulb used in small size cross symbol boder and original flame type(Deepam)?
What is the difference between Ceiling Fan armature and Tablefan Armature or winding.
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
How to Preparation of online test
tell me any book for current n potential trasformer with full knowledge ?
why the supply power frequency is 50hz in india? where as it is 60hz in US?
CAn any one can tell me what is the operation of ceiling fan and how it will start
What is the diffrence between PL Lamps and CFL Lamps
Three way plug point is there ,in that plug why we need earth pin is bigger than compare with phase and nutral pins?
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
In a HT switchboard where Nos. of Transformers are connected, how to decide Incoming cable size? Whether Cable should be rated for connected load or maximum demand?
Three phase star connected PT transformer primary side one phase fuse is blown what will be the output in secondary side(Secondary side also three phase star connected)
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)