In a ball valve which require 24v dc supply to operate, whose solenoid valve doesn't have any + or - indication, how can we make wiring connectionto solenoid valve?
Answer / narendra
u can connect diode & check it by providing power supply,as it will not damage the the solenoid even polarity is changed.
Is This Answer Correct ? | 2 Yes | 0 No |
ALL INSTRUMENTS WORKING PRINCIPLE.
3 Answers Blanco, India Cements, TVS,
Why Ma signal is using for control system?
what is pico fuse? how this different rom othe fuses and how to locate it inside the card?
how works encoder in plc
what is difference between OP AMP and differential amplifier?
In s7-200 we use HMI TD-200C , what that C stands for........ plz reply
Where we r using split range and ratio controller?
what is difference between modbus & fieldbus
how to online calibration of remote seal tx.
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
Qatar fertilizer call me for interview as Instrumentation Project Engineer. Please let me know what kind of question they asked ? ALso they said they will take Written test, any idea about this written test ?
what is maximum temprature in instrumentation