Why Dyn11 Transformer is selected for distribution transformer?
Answers were Sorted based on User's Feedback
Answer / ankit
firstly we want a neutral point at the load side because using one live wire and neutral we can form one phase.
secondly using delta star connections third harmonics is reduced
Is This Answer Correct ? | 2 Yes | 2 No |
what should be the motor rating for pumping water for house hold use from 60km far lake and what formula is to use please tell me
What is a circuit breaker contact multiplier relay?
what is battery impedance testing and how we perform this test with four wires.
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
how many maximum nos of add on contact we shd provide on 4 no contactor
why we are 0.8 power factor only?
How to work definite,over pluxing,revers power,OSR relay
what is power frequency withstand and impulse withstand of a circuit breaker?
Explain Energy and Power signals?
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
Which type of transformer is used for lighting loads?
what is the use of CurrentTransformer in AVR ?