Answer / carl_ellis

Difference between ultrasonic flow meter and radar type flow
meter

That's easy. Radar (radio frequency) energy is not widely
used, if at all, in commercial industrial flow meters.

Commercial ultrasonic flow meters use acoustic energy above
the range of human hearing to measure flow velocity of
liquids and gases. The measurement is inherently a
velocity measurement.

Transit time technology for liquids with no suspended solids
or bubbles, or doppler technology can be used for liquids
with suspended solids or bubbles. In-Line transit time
ultrasonic is accurate enough to be used for custody
transfer. Doppler has limited accuracy.

Carl Ellis
Measure First

Answer / patel

Ultrasonic works on Doppler and time transits. time taken for travel transmitter to receiver
Radar works on Echo generate by waves I mean reflective time and pressure of echo on quartz

field bus transmitter calibration procedure tell me

0 Answers   BAP,

---

i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?

0 Answers  

---

What is PDS and PDMS ?

0 Answers  

---

Control valve Flow characteristic. How the equal percentege curve form?

5 Answers  

---

What will the new flow factor if D/P Transmitter is RE-RANGED from 25" WC to 50" WC

3 Answers   ADMA OPCO,

---

How does work A temperature valve or fv control valve in process plz brief me

0 Answers   Jindal,

---

WHAT IS DIFFERENCE BETWEEN TWO WIRE RTD AND THREE WIRE RTD?

5 Answers   Yokogawa,

---

what is DCS and SCADA?

2 Answers   APL,

---

what is Instrument Schedule, and what it is mainly used for?

0 Answers  

---

How to calibrate the pressure Transmitters

1 Answers  

---

It is desired to reduce effect of 50Hz pick up in a thermocouple measurement. If a third order LP filter is used for this, what should be its cut off frequency, if gain should be 0.001 at 50Hz.

1 Answers   Honeywell,

---

What is the procedure of calibration of Load cell?

0 Answers  

---