Answer / mayank jain

simple, not need to calculate angle , mark horizontal
distance and vertical ,meet the points........also use
AutoCAD drawing for this purpose

Answer / mayank jain

simple, not need to calculate angle , mark horizontal
distance and vertical ,meet the points........also use
AutoCAD drawing for this purpose

Answer / chandra shekhar upadhyay

Calculation must be needed for stair case shuttring set up,from first landing bed if it is 1200mm - one trade (300x9)-2D(thicknes of slab)+remaning trade(300x8)

How to measure the requirement of cement n sand for 12mm and 20mm plastering thanks in advance

0 Answers  

---

How Can Calculate Plastering Quantities For 260.04 square meter by using CM 1:4 with 25mm Thick ?

2 Answers  

---

Cement sand mortar ratio 1:6 and 1:3. In canal lining 10mm & 16mm respectively done after 24hrs difference between them . Tell me Torrence limit of above ratio after 1 Year .

0 Answers  

---

calculate if the size of the beam is 300*500 then L for the top & bottom bar

2 Answers   ACPL,

---

Totally how many Grades of Concrete are there? and Explain Briefly?

2 Answers   Reliance,

---

asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream

0 Answers  

---

Please Clear My doubt . We Can Design the size of the beam by manually by the Length of the beam...What is the technique adopted

0 Answers  

---

what is the silt(for sand) allowed persentage as per IS CODE B/W: PLASTER: CONCRETE :

6 Answers   Trident,

---

what is irrigation

2 Answers   Era Infra Engineering, Prothious,

---

what is the proedure to do soundness test in cement? What is the maening of soundness? Why we do it for cement?

1 Answers  

---

what is SDLC ?and write a 'c'program for to swapping the three numbers?

0 Answers  

---

what is levelling staff least count

13 Answers   L&T,

---