which motor is used in our Indian Ceiling fan -Capacitor
start and run or Capacitor start?
(during repair i saw only one capacitor so it should be
start only)
Answers were Sorted based on User's Feedback
Answer / vinod kumar dwivedi
ceiling fan's motor is capicitor start & capicitor run type.
| Is This Answer Correct ? | 32 Yes | 4 No |
Answer / nandagopan
ceiling fan motors are capacitor start and capacitor run
motors.it needs only one capacitor.it has two windings
starting winding and running winding.starting winding has
more turns than running to produce torque.capacitor is
connected in series with starting winding.The capacitor
provides a phase shift.
| Is This Answer Correct ? | 15 Yes | 0 No |
Answer / sampath
since there is no centrifugal switch may be it is a capacitor start and run type
| Is This Answer Correct ? | 14 Yes | 2 No |
Answer / osama bin amjad
May be its helpfull to u.
Once I have faced the same problem.
u can also search for grundfos starting and running capacitor.
Starting capacitor is of high rating while running has its low value as compare to starting. Beacuse of the reason behind in starting motor required more torque and for its it required high discharge capacitor to start motor and after few seconds when motor comes to its normal rating/running than the other capacitor starts working for normal and smooth running.
therefore we called start and running capcitor as starter and running capacitor.
U can also see the wiring diagram in grundfos motor required starting and run capacitor. Relays or contactors used normally to start and run capacitor.
| Is This Answer Correct ? | 0 Yes | 0 No |
What is Phasing out test?
is 3-phase induction motor need a starter ? why do it so
how to make a solar panel? why solar panel cell connected to serious?
Where can i get practical knowledge of solar system?
what efficiency of transformer at 100% load
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
Who is reputed manufacturer of TNC switch for ACB in India ?
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
Why inductor short on dc and capacitor allow to flow ac?
Which are the types of breakers used in High Tension (HT) side?
why a diode bridge is provided in vcb control circuit ?
what is pressure relief valve?where it is used????
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)