Answer / k,prakashchandra

Find the current and > Xc . Use the formula Xc= 1/Cw to get
the value of C

Answer / jon

1 KVAR = 600 MFD

how does the harmonics enter into the induction motors?

1 Answers  

---

what will happen when the dc supply is given to the capacitor?

0 Answers  

---

What is the measuring instrument of magnetic flux density?

2 Answers   CSEB,

---

it says in neutral wire current flows under normal condition, but when we put tester it wont glow, why?

7 Answers   HCL,

---

I want to know the principle of rotating flux transformer.

1 Answers  

---

For a DY11 lighting Transformer on primary side whee to connect fourth lead? from nuetral or from ground?

3 Answers   Sabic,

---

How many types of instrument cables are there?

0 Answers  

---

what is the difference between MCB and MCCB?

4 Answers  

---

What are the layers of protection over armoured cables?

3 Answers   Accenture, IOCL,

---

we have 3 phase 4 wire supply 230/415 V.AC and our distribution is single phase or we have all single phase 220 v,ac operated appliances. and noted the current with help of clamp meter Red to N = 20 Amps. Yellow to N = 45Amps and Blue to N = 30 Amps ( total is 95 Amps ) what will be neutral current on the main .

1 Answers   ABC,

---

Energy metering: On the property I am renting, the supply voltage is 2 x 110 volts. These 2 x phases enter a energy meter which then exit the meter to over head lines to my house. Question 1. The meter is single phase 240 volts but is being used as 2 x phase(2 x 110volt), is this acceptable? if not, please give me the reasons. The meter details are as follows: 60Hz 15amp Imax 100 amp Kd 3,6 Wh/R 1 fase 3 hilos Model FX 231. I think it was manufactured in Brasil From this meter, the cables run along over head aluminum conductors,I estimate the cross sectional area to be 25mm diameter, but the neutral is only about 10mm square diameter, which cover a distance of 170 meters and then terminate with an underground cable of 65 meter length, total length = 235 meters. There must be a huge voltage drop over this length. This line is protected with 2 x 200 amp aluminum fuses after the meter, there is no main switch in the distribution board. These 2 phases connect directly onto 2 busbars. Surely the neutral should be the same size as the conductors if not more? Question2. What are your thoughts about this installation, should there be better protection, is the neutral too small? During the night, the lights dim then brighten all the time, this cannot be good for my electrical appliances. In my home, I only have a small electric geyser and fridge, my stove works off gas. But when i use other appliances like the washing machine or microwave oven, the light dim. The internal wiring of this house is done with solid hard drawn copper wires and of course, they have to be under rated. I am a retired electrician by trade, but not on the metering and over head mains side, my experience is on the factory maintenance side of things. Your expertise on these matters will be greatly appreciated. Please inform me how to rectify or make any improvements Kind regards, my power bill is very expensive, so I need to know how to bring it lower. Kind regards, Brian

1 Answers  

---

IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.

0 Answers  

---