What is the Good Earth resistance value of G.I & Cu.
Chemical Earthing & Normal Pipe Earthing?
No Answer is Posted For this Question
Be the First to Post Answer
What is the meaning of EDO in DG panels?
Draw the circuit of clapp oscillator?
According to ohms law voltage proportional to current, then why should current rating is low with high voltage rating in transformer?
define the non synchoronism of synchoronous machine in general g or m??
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
please can i know about total harmonic distortion and how i can calculate it and if anyone can help me to find any program to help me to calculate THD?? please need it
why dc series moter is not started at no load?
How will you calaculate the Ct ratio based on connected load 500KVA,and 11KV supply ?
How to calculate the cable size for particular load
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua