Answer / sumit banerjee

50D to 60D is the thumb rule for lap length, the lap length
depends upon grade of concrete and thickness of steel bars

Answer / nayan patel

yes it is coorect that it is the thumbrule for lap length
eg.50D OR 60D.the lap length varies as per grade of
concrete ,grde of rienforcement bar and most importnat is
the position of bar also whethere it may be in flexural
tension,direct tension or direct compression

Answer / sjtbehera

yes it is correct. it is a thumb rule for site execution.
but it vary on grade of concrete and steel. say in m20 grade
normally 41d for lap length

What are the important hardware systems used for cad?

0 Answers  

---

what are the code used for residental building?

0 Answers  

---

what is FPS brick

2 Answers  

---

what"s the minimum content cement allowed in RCC?

11 Answers   ABC, L&T,

---

# 1. size of the Bricks # 2. Minimum Crushing Strength of Bricks

5 Answers   Brigade,

---

Which is the IS code Using for Cement Sand Mortar

5 Answers   HPCL,

---

m25 water cement ratio calculation

1 Answers  

---

WHAT DLC DESIGN IN CONSTRUCTION

0 Answers  

---

where will be the reinforcement of slab placed when there is an inverted beam and the bottom of the beam and slab are at same level ?

0 Answers  

---

why 50% more is assumed while calculating dry volume of coarse and fine aggregates in concrete calculations.whether 50% more is correct? How is it decided? whether the same is applicable to cement volume. Also what about cement mortar dr volume? How much more is to be considered for dry volume of mortar.

1 Answers  

---

What is bending movement formula define

1 Answers   L&T,

---

wat is the necessity of finding shear and bending moment in a structure. wat will happen if it is not consider. other than shear cracks and deflection is there any other failure happen.

1 Answers  

---