how will we calculate the copper wire load..
No Answer is Posted For this Question
Be the First to Post Answer
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
what is post close & pre close of trip circuit supervision relay in circuit breaker control scheme?
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
the total iron closs in a transformer core at normal flux density was measured at 25hz and 5ohz and was found to be 250w and 800w respectively.the hysteresis loss at 50hz would be................?????
what happen if steam turbine trip,g.c.b not open and excitation off and on condition?
For high voltage and low current Circuit Breaker preferred is vacuum circuit breaker.why?
Please explain, how to test vector group of tranformer(Delta y1) . Thank
maintenance parameters of sewage treatment plant
how to calculate the capacity of the AC motor
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
why ht alternators gland plats using brass?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)