Answer / sudesh kumar

As we know that the rating of the transformer remains same as we consider it from the HT or LT side. The o/p can be determined by multiplying the rating with the power factor (i.e. 0.8 which is a standard value).

KW o/p = KVA * p.f.
= 25*0.8 KW
= 20 KW

Answer / s girish kumar

The Output of the transformer depends on its load .,means whether it is capacitive or inductive.,But approximately we will take the powerfactor as 0.8.
So If 25 Kva transformer then it is 25*0.8=20KW.It means maximum we can supply this much of consumers

Answer / guest

25*0.8=20kw

what is the ciruit diagram of transformer vector grup test?

4 Answers   Green Power,

---

what is the major difference between LIBBP & HIBBP.. which one is most preferable..

0 Answers   ABB,

---

aeroline vibration is present

1 Answers   DVC,

---

Explain types soft starters?

7 Answers   Siemens, TCS,

---

for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance

0 Answers  

---

Mathemetical Relation Between KWRH and KWH?

3 Answers   UPPCL,

---

What is difference between miniture circuit breaker and module case circuit breaker up to 63Amp.

7 Answers   MSPL,

---

what is tower earthing and what for it is required

1 Answers  

---

can we use heat gun instead of gas torch in 11kv termination kit. I mean can both sources provide enough amount of heat to ensure the uniform shrinkage of sleeve.

1 Answers  

---

CPC cable .PVC \1C....I want to get sure that type is flexible indoor or to be install on trench. please advice .thanx :)

0 Answers  

---

How many distance in distribution pole OR 33Kv line pole

2 Answers   Sail,

---

Why neutral is used in electrical system?

2 Answers  

---