Draw a 230kv two-bus bar system showing the following.
1.Two generators (150MW) each connected through one
15.75/230KV transformers
2. 1 outgoing lines
3. Two 230/130 KV transformers
4. BUS PT's 5. CT
No Answer is Posted For this Question
Be the First to Post Answer
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
what power factor should we maintain to get maximum benefits our organisation load is 10 MW? is it best to maintain the PF at .96 rather than Unity to save electricity bill?
as we know that N=120f/P speed of an im can be controled only through changing no if poles, can we control by changing the frequncy????
What is the Ramping rate of Generator. What mena Ramping rate
what are doing the duall connetion in tree phase 10hp or etc motor with circuit diagram
what is the difference between main meter CT and check meter CT?and what is the difference between main meter PT and check meter PT?
1.why ACB is not connected in HT side what Happens? 2.how much voltage maintained in ACB breaker? 3.OLTC is connected in primary side in case secondary side connected what happened?
What is CBCT ? Why & Where it is used?
which on of the transformer have more core losses and why? 1. Distribution Transformer 2. Power Transformer
what is doubling factor in making current of a breaker?
wht is embedded systems? what is new inthis field?
what is the formula to convert from KVAr to current?
1 Answers Halcrow International Partnership,