How can you start-up the 40w tube lite with 230v AC/DC
without using any choke/Coil?
Answers were Sorted based on User's Feedback
Answer / shailendra
we can use 200w bulb insted of choke. or
we can use about to one bucket water. in
the place of choke connect two electrode
of battery cell and drop both electrode
in water bucket.
Is This Answer Correct ? | 4 Yes | 1 No |
Answer / katrina kaif
becuse current passes through to choke\coil if we are not using choke so we do the short of rode wire.
Is This Answer Correct ? | 1 Yes | 0 No |
if the 10 hp motor name plate indicates rated current as 13.6 amp the what will be the thermal relay setting? Why? And in how much time relay will trip at the set value?
briefly explain principle of resistance welding
HOW DISTANCE PROTECTION IS DONE IN EHV TRANSMISSION LINES? WHAT IS THE BASIC TECHNIQ OR FUNDA USED BEHIND THIS ? SPECIALLY EXPLAIN?IMPEDANCE METHOD.
How much current can a 3-1/2 core 100 mm wire carry?
3 Answers Epitome, Focus, Focus Energy,
why we are using the 2 slope in differential relay?but in busbar differential we are using only one slope. what is the reason.
why 3phase is 440v but where as we get phase voltage 220v,we have to get 220*3=660v.can u pleas give in detailed
Mention how NPN and PNP transistor works?
WHY DIODE IS CONNECTING ACROSS SWITCHES
difference between turns ratio and transformation ratio?
1.what is surge 2.what is lightning 3.what is switching 4.difference between surge,lightning,switching used in power system 4.definition of surgearrestor,lightningarrestor 5.adv and disadv of surgearrestor,lightningarrestor 6.uses and purpose of surgearrestorand lightning arrestor 7.block dia of surge arrestor 8.blockdiagram of lightning arrestor 9.operation and working of surge arrestor and lightning arrestor 10.basic formula of surgearrestor and lightning arrestor 11.basic diagram of surge arrestor and lightning arrestor
1 Answers Crompton Greaves, Framo, L&T,
why the Parameters : Base Voltage & Maximum Voltage can't be equal in value in a VFD (Variable Frequency Drive) ? How much the base voltage would be lower than the maximum voltage ? If 400 V is the 3 phase output of a VFD ... then what should be the base voltage ? thanks a lot
what is excitation/
0 Answers ABB, Tata Steel Limited,