why an ideal voltage source has low internal resistance????
Answer / bala
ideal voltage source voltage is constant at all loads. so that
it should have low internal resistance to minmise I2r loss due
to current. therfore it has low internal resistance.
Is This Answer Correct ? | 1 Yes | 1 No |
The unit of resistivity is:(a) ohms(b) ohm millimetre(c) ohm metre(d) ohm/metre
what is meant by tranformer impedance?
What are the different types of LT Cables?
how cables go in and come out for distribution from the feeder pillar box?
to calculate voltage drop of cable which current we consider that means full load current or panel size?
Should transformer earthing pit, to be connect to earthing mat in Substation
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
For polarity test on a 11/3.3kV 2.5MVA delta-star Unit Auxiliary transformer,415V 3-phase supply was applied at the HV. Connection between Aa was made with a 2.5mm cable. As soon as power was switched on the cable caught fire and burnt. This test was then abandoned. It is noteworthy to say that a similar cable was also used in a similar transformer for the same. The cable did not burn and test was successfully completed with good result. What is wrong? Please, help me out.
I have 11KV/415V power distribution transformer. I have found unbalance current in LT (415V) side. Also observed that unbalance voltage (3V) at LV side due to HV side unbalance voltage. What should I check for this? Also, the same LV side load can run in balance on captive power.
What is safety of Ht panel
What the capacitor Current formula?, For 1 KVAr how amps its required? for using the KVAr for boosting the PF Design Calculation.( Eg: for 30 KVAr required how many KW?)
17 Answers Alstom, Call Centre, EDC, HCL, Procon Engineers,
11KW Delta motor is taking about 44Amps in star and goes upto 70Amps in delta and trips OFF. The rated current is 26Amps. Application is for the blower. The motor takes ( no load without coupling impller ) only 2.5A and 5Amps in star & delta starter test.Need to know why its taking high current.