Is 2000kva stabilizer suitable for 1h.p split air conditional
Answers were Sorted based on User's Feedback
Answer / jeetu ji
At 0.8 power factor, KW value of this stabilizer is 1600 KW
which is quite high value for 1 hp = 746 watt
We can use it but preferably a stabilizer of 1 KW is
sufficient.
Is This Answer Correct ? | 7 Yes | 0 No |
What are the drawbacks of HVDC system?
what happened if power factor is "1"
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
hi friends can u tell me name of the sites where i can get animation of electrical machines......
Master trip relay code no
If we have 15000kw connected load in a factory than how much power demand sanction should be taken from electricity board. Pls provide complete calculation.
how many methods for starting an induction motor?
7 Answers Hindustan Unilever Limited, Hyundai, TPL,
state application of relay in transmission line?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
What is the difference between voltages or potential difference? And what are they?
plz tell me about BACK emf and how it generates?