1. Centrifugal pump is used to drain the coolant from the
machine to coolant tank via magnetic separator and paper
filter. But more foam is raising in the coolant tank. We
need to arrest the foam formation inside tank which is nt
desired. How do we correct this issue? (Hardness of the
water is at recommended ppm).
Answers were Sorted based on User's Feedback
Answer / vigneshwar r
Foam is mainly produced due to higher velocity.In order to
reduce the velocity, as per the continuity equation, area
should be increased.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / kp
one can simply use a rotary pump istead of a centrifugal pump...as the centrifugal pump causes foam formation of the fluid.
Is This Answer Correct ? | 0 Yes | 0 No |
What are the most immediate challenges of this position that need to be addressed in the first three months?
why we use charcoal layer in aqua silencer to purify the gases??
Why pert is preferred over cpm for evaluation of project ?
DRAW SFD & BMD OF SIMPLY SUPPORTED ,CANTILEVER, UNIFORMLY DISTRIBUTED BEAMS
2 Answers Nagarjuna Construction,
What happen when too much cylinder oil is injected in the working cylinder?
define piston
Given a cutaway isometric view of the steam turbine.
0 Answers ABC Inc, RRB, Siemens,
what is the purpose of wear rings in centrifugal pumps ?
what is bulk density
How to find bearing outer dia with bearing number
write the formula for finding dimension of bearing from bearing number
11 Answers Coromandel Agrico, FAG, Jain Group, Jindal, Kyro, MG, Quess Corp, Seven Star, SKF, Vedanta,
Hello, I am PRAVEEN, working with start-up company as design, I don have any sap experience. but I wanted to join mm course in atos. Is it good change domain?