Why should we use jelly filled armoured cables in underground Communication sy

Why should we use jelly filled armoured cables in underground
Communication system? What is the use of the Jelly? If we go
for unarmoured, then what happens?

Question Posted / ramsel1985

1 Answers
3986 Views
Prasad Group, I also Faced
E-Mail Answers

Why should we use jelly filled armoured cables in underground Communication system? What is the us..

Answer / sarmadahmed

I'm not sure but jelly is used to absorb moisture which means cable's insulation will have longer life.

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?

0 Answers

Caliculate the Specific Fuel consumption of 320 kva diesel genarator set?

3 Answers AllTech, RRB,

Whatis the procedure for getting Electrical (light) licence while Iam a diploma holder in electrical Engg . I Compleated my one yr Apprentice training & worked as a junior engineer (ele) for 2 yr(contract basis).

1 Answers TVS,

What is an isolation transformer?Why do we need isolate circuits?Where do we use them?

2 Answers

why we connect dg neutral with ground?

1 Answers

why solinoid coil used in tripping rely?and why not other type coil?

1 Answers

how to syncronize two dg sets

3 Answers

what is the difference between neutral and earth????

4 Answers

what is the length of air terminal in lightening arrester system.

1 Answers

what happens if you swap F1 and F2 connection in the exiter of the generator?

1 Answers

why tungsten is used in incandescent lamp instead of nichrome though nichrome has high melting point

2 Answers

What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?

0 Answers HPCL,

For more Electrical Engineering Interview Questions Click Here