Answer / markwilcon

Transmitter=0.005 x 2500 = 12.5

comparison gauge = 0.001 x 3000 = 3

Am i on the right track?

WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?

0 Answers   Artikal, ITC Infotech,

---

why pressure 3-15psi is used as industrial standard and what is the reason

2 Answers   JAL International, UltraTech,

---

What is the difference between DCS and SCADA?

1 Answers  

---

What is sensitivity of K type thermocouple? Is polarity important in thermocouple connections?

3 Answers   Honeywell,

---

What is the cascade control system and where is use in power plant give the detail with block diagram

1 Answers  

---

What is the solution if rotork motorised control valve showing pink Colour in dcs.

3 Answers   Bhushan Power Steel,

---

Waht is surge in compressors and how to control it?

1 Answers   DEWA,

---

Difference b/w SCADA & DCS

8 Answers   Siemens,

---

How can we cheak the ENCODER ?

1 Answers  

---

1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling

0 Answers   BARC,

---

what is the input to be given digital temp controller during the the calibration time?

2 Answers  

---

Can we use PLC in Hazardous Area?

2 Answers   MNHG,

---