WHY TORSION SHAFT IS GIVEN IN BALL MILL DRIVE. IS THIS HAS A
ANY TECHNICAL REASON?
Answer / gajendra swami
to increase the fatigue strenght of the shaft.
Is This Answer Correct ? | 4 Yes | 1 No |
What should be done to prevent a safety valve to stick to its seat ?
Explain the difference between “stress and strain”?
what is differential expansion?
For hot water : please compare to solar heat and heat pump (environment/operation/invest...) Is there any comparison available. Thank you
what is difference between main steam to dearator & pegging steam to dearator?
why vertical type mufflers are used in highway trucks? (other them space constrain)
In what conditions it is necessary to trip the boiler? what about burner in these conditions?
WHAT IS DIFFERENCE BETWEEN ANNEALING,TEMPERING AND NORMALIZING
What are the causes of positive and negative propeller slip?
what is the thickness tolerances up to 32 mm
What speed you will select to drill 10 mm. In MS Plate ?
how to calculate air load of a existing/ new plant before installing a air compressor.