what is setup time and hold time ?
Answer / reza r
Setup time is the time before the edge of the clock (In a
flip-flop) that the data must be held steady to be sampled
correctly.
Hold time is the time after the edge of clock that the data
must be held steady to be fully applied to the FF.
Is This Answer Correct ? | 1 Yes | 0 No |
What is High frequency transformer cores made of?
What is a Quality Factor?
19 Answers AML, IIT, L&T, Nalco,
2. What is the command to lock the TRX
Explain the difference between silicon controlled switch (scs) and gate turn-off switch (gto)?
What is the difference between <stdio.h> and "stdio.h"?
how to find the fault in smps if i am not getting the output
What is the difference between 8087 and 8086
what Rx and TX power good RF conditions.
What is vom?
what is beamwidth in case of antenna system
Define what are the main purposes for which a common-collector amplifier may be used?
what is the vertual short&vertual ground?