how to set relay setting? and example calculation...
No Answer is Posted For this Question
Be the First to Post Answer
What happen if 200 KVAR capacitor connected to power continuesly?
If two hack saw blades, seperated by 1mm thick paper,are connected across 230volts, and immersed in water,then they start getting heat. This is fact,i dont know how they get heated.Blades are not directly connected together. Please if anybody knows the fact ,revert back to me
what is phase shifting transformer.
What is the direction of rotation of blades in a table fan and in a ceiling fan ?
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
opkinson's test
how long will take to burst/damage for a CT when secondary in open condition? Experienced: During switchgear testing(Primary current injection test) some of the CT are in open condition, but nothing happen's why?
What is the difference between AC voltage and DC voltage?
In the case of petrochemical area AC drive & AC motor is used where the speed variation is required. Why they are not Using DC drive & DC motors in such areas?
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
What kind of preventive maintenance are there for AC generator?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)